Subaru Crosstrek Service Manual: Basic diagnostic procedure Procedure

1.PERFORM CUSTOMER INTERVIEW.

Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Check List for Interview > CHECK">

Did you interview the customer?

Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.

Interview the customer. Check List for Interview > CHECK">

2.CHECK SUBARU SELECT MONITOR COMMUNICATION.

Using the Subaru Select Monitor, check whether communication to the telematics system can be executed.

NOTE:

If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. (Refer to "Communication for initializing impossible".) Subaru Select Monitor > INSPECTION">

Is communication possible?

Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.

Check the communication circuit.

3.CHECK TELEMATICS.

Using the Subaru Select Monitor, read DTC of the telematics system. Diagnostic Code(s) Display > OPERATION">

NOTE:

If DTC is detected, only RED LED will illuminate. For details, refer to "LED operation status list". Check List for Interview > CHECK">

Is DTC displayed?

Perform the diagnosis for the displayed DTCs. Diagnostic Code(s) Display > LIST">

Basic Diagnostic Procedure > PROCEDURE">Go to Step 4.

4.CHECK DIAGNOSTICS WITH PHENOMENON.

Check the list of Diagnostics with Phenomenon. Diagnostics with Phenomenon">

Does the symptom apply?

Perform diagnosis according to the procedures in the diagnostics with phenomenon.

Basic Diagnostic Procedure > PROCEDURE">Go to Step 5.

5.CHECK TROUBLE PHENOMENON.

1) Perform the basic inspection and function check. General Description > INSPECTION">

2) Check the data communication module. Control Module I/O Signal">

3) Perform check of current data. Read Current Data">

4) Perform a unit check.

Was the trouble cause found?

Perform the Clear Memory after repairing or replacing the cause of trouble. Clear Memory Mode">

System is normal.

Operation

Check list for interview Check

Other materials:

Subaru select monitor Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ CURRENT DATA1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, inp ...

Dtc c1811 system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1811 SYSTEMDTC detecting condition:ABS and VDC long time sequential controlTrouble symptom:• ABS does not operate.• VDC does not operate.• EBD may not operate.• Hill ...

Memory function
The Subaru Ascent power rear gate is equipped with a convenient memory function that allows you to store a preferred opening height for everyday use. This feature is especially useful in garages or areas with limited vertical clearance. Registration of the rear gate height To set and save your ...