Subaru Crosstrek Service Manual: Assembly

Subaru Crosstrek Service Manual / Clutch system / Operating cylinder / Assembly

CLUTCH SYSTEM > Operating Cylinder

ASSEMBLY

NOTE:

During assembly, apply hydraulic oil to all parts.

Recommended brake fluid:

New FMVSS No. 116 DOT3 or DOT4

1. Install the piston spring.

2. Insert piston into the operating cylinder.

3. Install push rod to the boot.

4. Install the boot and push rod.

CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconne ...

Other materials:

Disassembly
CLUTCH SYSTEM > Master CylinderDISASSEMBLY1. Remove the straight pin and nipple.(A)Nipple(B)Straight pin2. Remove the oil seal.(A)Oil seal3. Move the seat towards the rear.(A)Seat(B)Master cylinder4. Remove the piston stop ring.CAUTION:When removing the piston stop ring, be careful to prevent the ...

Installing forward facing child restraint
WARNING Before installing a child restraint system, be sure to confirm that the seatback is securely locked into place. Otherwise, in an accident, serious injury or death could result. 1. Shake the seatback slightly to confirm that it is securely locked into place. It is possible to check ...

Removal
SECURITY AND LOCKS > Starter Relay (Push Button Start)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from bat ...