Subaru Crosstrek Service Manual: Adjustment
WIPER AND WASHER SYSTEMS > Front Wiper Arm
ADJUSTMENT
1. Operate the windshield wiper once.
2. Check that the wiper blade is aligned with the point mark.
3. Make sure that there is a gap of 1 mm (0.04 in) or more between the hose and the cover joint and between the hose and the joint washer hose during windshield wiper operation.
(A) | Gap between hose and cover joint outer side | (C) | Gap between hose and cover joint inner side | (D) | Gap between hose and cover joint lower side |
(B) | Gap between hose and cover joint upper side |
4. If there is a gap between the hose and the cover joint, a gap between the hose and the joint washer hose and misalignment of the point mark, remove and install the windshield wiper. Front Wiper Arm > REMOVAL">
Front wiper arm
...
Removal
WIPER AND WASHER SYSTEMS > Front Wiper ArmREMOVAL1. MODELS WITHOUT EyeSight1. Remove the cover - windshield wiper arm.2. Remove the nuts, and remove the arm assembly - windshield wiper.2. MODELS WI ...
Other materials:
Vehicle load limit - how to determine
The load-carrying capability of your Subaru Ascent is defined by weight limitations
rather than available interior or cargo space. The maximum permissible load is clearly
indicated on the vehicle placard located on the driver’s side door pillar. On this
label, you will find the statement: &q ...
Dtc b1642 side satellite sensor bus rh lost communication
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1642 SIDE SATELLITE SENSOR BUS RH LOST COMMUNICATIONDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Side airbag sensor (R ...
Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with the radar sensor is impossibleDetecting condition:• Defective harness connector• Power supply circuit malfunction• Def ...
