Subaru Crosstrek Service Manual: Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch Assembly
ADJUSTMENT
1. Install the thrust bearing to the internal gear.
NOTE:
Face the temper color surface to the reverse brake side.
2. Measure depth “A” from the ST upper face to the washer mounting surface.
| ST 499575600 | GAUGE |
3. Measure the height “B” from the ST upper face to the mating surface of the drive pinion retainer.
| ST 499575600 | GAUGE |
4. Obtain the thickness of washer using the following formula to select the washer.
T (mm) = A − B − (0.35 — 0.70)
[T (in) = A − B − (0.014 — 0.028)]
T: Shim thickness
A: Depth from the ST upper face to the washer mounting surface
B: Height from ST upper face to the drive pinion retainer mating surface
0.35 — 0.70 mm (0.014 — 0.028 in): Clearance
Washer | |
Part No. | Thickness mm (in) |
803064020 | 1.3 (0.051) |
803064021 | 1.55 (0.061) |
803064022 | 1.8 (0.071) |
803064023 | 2.05 (0.081) |
803064024 | 2.3 (0.091) |
803064025 | 2.55 (0.100) |
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the ...
Other materials:
Dtc b14e1 air mix door actuator stepping motor circuit open (driver)
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E1 AIR MIX DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPEN (DRIVER)DTC detecting condition:Air mix door actuator stepping motor circuit is open.Trouble symptom:Temperature cannot be adjusted.Wiring diag ...
Dtc p0336 crankshaft position sensor "a" circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0336 CRANKSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Failure ...
Component
FRONT SUSPENSION > General DescriptionCOMPONENT1. FRONT SUSPENSION(1)Front crossmember COMPL(14)Bushing rear - front arm(27)Clip(2)Flange bolt(15)Stud bolt (3)Front crossmember support(16)Stopper - front arm bushing rearTightening torque: N·m (kgf-m, ft-lb)(4)Front stabilizer(17)AdapterT1 ...
