Subaru Crosstrek Service Manual: 35
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code
35
Detected when it is impossible to perform the vehicle speed feedback.
Set vehicle speed cannot be kept for some reasons (steep uphill, unreleased parking brake, etc.) during cruise driving.
Cancel code is detected when driving conditions are not suitable for cruise control.
Perform cruise set operation again after clearing the possible cause.
34
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code34The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) during cruise dr ...
41
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code41VDC/TCS/EPB is operated.Vehicle dynamics control (VDC) or TCS/EPB is operated during cruise driving or cruise setting. B ...
Other materials:
Sensors
Interior air temperature sensor
Solar sensor
The automatic climate control system
employs several sensors. These sensors
are delicate. If they are not treated
properly and become damaged, the system
may not be able to control the interior
temperature correctly. To avoid damaging
th ...
Shifting speeds
Recommended shifting speeds
The best compromise between fuel economy
and vehicle performance during
normal driving is ensured by shifting up
at the speeds listed in the following table.
Maximum allowable speeds
The following table shows the maximum
speeds that are possible with each differe ...
To increase the speed (by the "RES/ SET" switch)
Press the "RES/SET" switch to the "RES"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...
