Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: 22

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code

22

Malfunction related to vehicle speed sensor is detected.

DIAGNOSIS:

Open or shorted circuit in vehicle speed sensor system.

TROUBLE SYMPTOM:

Cruise control cannot be set. (Cancelled immediately.)

STEPCHECKYESNO

1.CHECK ABS OR VDC WARNING LIGHT.

1) Turn the ignition switch to ON.

2) After the initial operation of combination meter is completed, check if ABS or VDC warning light continues to illuminate.

Does the warning light continue to illuminate?

Check the VDCCM.
Basic Diagnostic Procedure">

Diagnostic Procedure with Cancel Code > 22">Go to Step 2.

2.CHECK DTC OF LAN COMMUNICATION CIRCUIT.

Read the DTC of body integrated unit using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is DTC displayed?

Perform inspection according to DTC.

Replace the ECM.
Engine Control Module (ECM)">

21
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code21Cruise control command switch malfunction is detected.TROUBLE SYMPTOM:• Cruise control cannot be set. (Cancelled i ...

24
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code24Malfunction in cruise control-related switch is detected.TROUBLE SYMPTOM:• Cruise control cannot be set. (Cancelle ...

Other materials:

Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smooth ...

Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...

Dtc b2a0a red led circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0A RED LED CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at le ...

© 2016-2026 Copyright www.sucross.com