Subaru Crosstrek Owners Manual: Using a flat-bed truck
This is the best way to transport your vehicle. Use the following procedures to ensure safe transportation.
1. Shift the select lever into the "P" position for CVT models. Shift the shift lever into the "1st" position for MT models.
2. Pull up the parking brake lever firmly.
3. Secure the vehicle onto the carrier properly with safety chains. Each safety chain should be equally tightened and care must be taken not to pull the chains so tightly that the suspension bottoms out.
CAUTION
If your vehicle has a front underspoiler and rear underspoiler (both optional), be careful not to scrape them when placing the vehicle on the carrier and when removing the vehicle from the carrier.
Rear tie-down holes
Rear tie-down hole
The rear tie-down holes are located near
each of the jack-up reinforcements.
There is a plug in each rear tie-down hole.
To use the rear tie-down holes, remove
the ...
Towing with all wheels on the ground
1. Release the parking brake and put the
transmission in the "N" position.
2. The ignition switch should be in the
"ON" position while the vehicle is being
towed.
3. Take up slack in the ...
Other materials:
Dtc c1561 reverse off fault
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1561 REVERSE OFF FAULTNOTE:For the diagnostic procedure, refer to “DTC C1562 REVERSE ON FAULT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1562 REVERSE ON ...
Loading your vehicle
WARNING
Never allow passengers to sit or ride in the cargo area of the Subaru
Ascent, especially on folded rear seatbacks. This practice is extremely dangerous
and can result in serious injury in the event of sudden braking or a collision.
Do not stack luggage or cargo higher than the to ...
Dtc b14e6 mode door actuator stepping motor circuit short-circuit
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E6 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT SHORT-CIRCUITDTC detecting condition:Mode door actuator stepping motor circuit is shorted.Trouble symptom:Vent does not change.Wiring diagram:Air condi ...
