Subaru Crosstrek Owners Manual: Tire care - maintenance and safety practices
- Check on a daily basis that the tires are free from serious damage, nails, and stones. At the same time, check the tires for abnormal wear
- Inspect the tire tread regularly
and replace the tires before their
tread wear indicators become visible.
When a tire's tread wear indicator becomes visible, the tire is worn beyond the acceptable limit and must be replaced immediately.
With a tire in this condition, driving at even low speeds in wet weather can cause the vehicle to hydroplane.
Possible resulting loss of vehicle control can lead to an accident.
- To maximize the life of each tire
and ensure that the tires wear
uniformly, it is best to rotate the
tires every 7,500 miles (12,000 km).
For information about the tire rotation order, refer to "Tire rotation" F11-26. Replace any damaged or unevenly worn tires at the time of rotation. After tire rotation, adjust the tire pressures and make sure the wheel nuts are correctly tightened.
For information about the tightening torque and tightening sequence for the wheel nuts, refer to "Flat tires" F9-5.
Glossary of tire terminology
Accessory weight
The combined weight (in excess of
those standard items which may be
replaced) of automatic transmission,
power steering, power brakes,
power windows, power seats, radio,
an ...
Vehicle load limit - how to determine
The load capacity of your vehicle is
determined by weight, not by available
cargo space. The load limit of
your vehicle is shown on the
vehicle placard attached to the
driver's side door pillar. ...
Other materials:
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Oil Temperature SensorINSPECTION1. Check that the engine oil temperature sensor has no deformation, cracks or other damages.2. Immerse the engine oil temperature sensor and a thermometer in water.CAUTION:Take care not to allow water to get into the eng ...
16
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code16Detected when ignition switch is turned to OFF or malfunction related to the ignition switch occurs.TROUBLE SYMPTOM:Cruise control cannot be set.WIRING DIAGRAM:Cruise control system Cruise Control System > WIRING DIA ...
Electrical component location Location
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Engine control module (ECM)(4)Cruise indicator light and cruise set indicator light(7)Neutral position switch (MT model)(2)Cruise control command switch(5)Transmission control module (TCM) (CVT model)(8)Clutch switch (M ...
