Subaru Crosstrek Owners Manual: Stopping the engine
The ignition switch should be turned off only when the vehicle is stopped and the engine is idling.
WARNING
Do not stop the engine when the vehicle is moving. This will cause loss of power to the power steering and the brake booster, making steering and braking more difficult. It could also result in accidental activation of the "LOCK"/"OFF" position on the ignition switch, causing the steering wheel to lock.
CVT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Shift the select lever to the "P" or "N"
position (preferably the "P" position).
The starter motor will only op ...
Starting and stopping engine (models with
push-button start system)
Safety precautions
Refer to "Safety precautions" F2-10.
Operating range for push-button start system
Refer to "Operating range for push-button
start system" F3-6. ...
Other materials:
Ventilator control
Center and side ventilators
Center ventilators
Open
Close
Side ventilators
Open
Close
To adjust the flow direction, move the tab.
To open or close the ventilator, turn the
thumb-wheel up or down. ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...
Removal
SECURITY AND LOCKS > Immobilizer AntennaREMOVAL1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to right and left.(2) Release the claw, and re ...
