Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Hvac system (heater, ventilator and a/c) / Blower resistor (manual a/c model) / Inspection

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)

INSPECTION

1. Check the resistance between resistor terminals.

Preparation tool:

Circuit tester

Terminal No.	Standard	Connection diagram
4 — 3	Approx. 0.43 ?

4 — 2

Approx. 1.03 ?

4 — 1

Approx. 3 ?

2. Replace the resistor if the inspection result is not within the standard.

Blower resistor (manual a/c model)

...

Removal

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the glove box. Glove Box > REMOVAL" ...

Other materials:

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Delivery and Evaporation LinesINSTALLATIONInstall in the reverse order of removal while being careful of the following.NOTE:When connecting the fuel delivery tube (a) and evaporation hose (b), let the bushing (c) contact the quick connector (d) of fuel d ...

Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...

Assembly
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxASSEMBLY1. Install the tie-rod into rack.Tightening torque:90 N·m (9.18 kgf-m, 66.4 ft-lb)NOTE:Check the mating face of rack and tie-rod for foreign matter such as dust etc.2. Apply a coat of grease to the tie-rod groo ...