Subaru Crosstrek Service Manual: Specification
COOLING(H4DO) > General Description
SPECIFICATION
Cooling system | Electric fan + forced engine coolant circulation system | |||||
Total engine coolant capacity | L (US qt, Imp qt) | CVT model | Approx. 8.4 (8.9, 7.4) | |||
MT model | Approx. 8.0 (8.5, 7.0) | |||||
Water pump | Type | Centrifugal impeller type | ||||
Discharge performance | Discharge rate | L (US gal, Imp gal)/min | 230 (60.8, 50.6) | |||
Pump speed — Discharge pressure | 6,600 r/min — 88 kPa (9 mAq) | |||||
Engine coolant temperature | 80°C (176°F) | |||||
Impeller diameter | mm (in) | 60 (2.36) | ||||
Number of impeller vanes | 7 | |||||
Pump pulley diameter | mm (in) | 130 (5.12) | ||||
Thermostat | Type | Wax pellet type | ||||
Starting temperature to open | Engine side | 90 — 94°C (194 — 201°F) | ||||
CVTF cooler (with warmer feature) side (CVT model) | 48 — 52°C (118 — 126°F) | |||||
Fully opens | Engine side | 100°C (212°F) | ||||
CVTF cooler (with warmer feature) side (CVT model) | 63°C (145°F) | |||||
Valve lift | mm (in) | Engine side | 8.0 (0.315) or more | |||
CVTF cooler (with warmer feature) side (CVT model) | 6.0 (0.236) or more | |||||
Valve opening size | mm (in) | Engine side | 32 (1.26) | |||
CVTF cooler (with warmer feature) side (CVT model) | 22 (0.87) | |||||
Radiator fan | Motor input | Main fan | W | 120 | ||
Sub fan | W | 120 | ||||
Fan diameter / Blade | Main fan | 320 mm (12.6 in)/9 | ||||
Sub fan | 320 mm (12.6 in)/11 | |||||
Radiator | Type | Down flow, pressure type | ||||
Core dimensions | Width ? Height ? Thickness | mm (in) | 687.4 ? 340 ? 16 (27.06 ? 13.39 ? 0.63) | |||
Pressure range in which cap valve is open | kPa (kg/cm2, psi) | Positive pressure side | Standard | 93 — 123 (0.95 — 1.25, 14 — 18) | ||
Limit | 83 (0.85, 12) | |||||
Negative pressure side | Standard | −1.0 to −4.9 or less (−0.01 — −0.05, −0.1 — −0.7) | ||||
Fins | Corrugated fin type | |||||
Reservoir tank | Capacity | L (US qt, Imp qt) | 0.45 (0.48, 0.40) | |||
Recommended materials | Item number | Alternative | |
Coolant | SUBARU SUPER COOLANT (concentrated type) | — | — |
SUBARU SUPER COOLANT (diluted type) | K0670Y0001 | ||
Water for dilution | Distilled water | — | Soft water or tap water |
Cooling system protective agent | Cooling system conditioner | SOA345001 | — |
Caution
COOLING(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a ...
Component
COOLING(H4DO) > General DescriptionCOMPONENT1. WATER PUMP(1)Water pump pulley(13)Clip(25)Gasket(2)Water pump ASSY(14)Water pipe hose RH(26)Engine coolant temperature sensor(3)Gasket(15)Water pipe A ...
Other materials:
Dtc p2530 ignition switch run position circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Cl ...
Auto light sensor sensitivity setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Auto Light Sensor" item. Then
push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Selec ...
Dtc b1698 door sensor lh initialization incomplete
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1698 DOOR SENSOR LH INITIALIZATION INCOMPLETEDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Front door impact sensor (LH ...
