Subaru Ascent 2018-2026 Owner's Manual: Seat ventilation
The Subaru Ascent is equipped with seat ventilation for the front seats, providing enhanced comfort during warm weather conditions.
The seat ventilation system operates when the ignition switch is in the "ON" position.
CAUTION
- Avoid placing heavy or sharp objects on the ventilated seats of the Subaru Ascent, as this may damage internal components.
- Do not use harsh cleaning agents such as thinner, benzene, or alcohol when cleaning the seats.
- If liquid is spilled on the seat, wipe it immediately with a dry cloth to prevent damage to the ventilation system.
NOTE
- Extended use of seat ventilation in the Subaru Ascent with the engine off may cause battery discharge.
- The seat ventilation system cannot operate одновременно with the front seat heater.
- For prolonged use, select MID or LOW settings.
Use the HIGH setting only for quick cooling at the beginning of operation.
Adjust the seat ventilation function through the center information display in the Subaru Ascent for optimal comfort and climate control.
Seat heater
The seat heater system in the Subaru Ascent operates when the ignition switch
is in the "ON" position, providing additional comfort during cold weather conditions.
CAUTION
Do not plac ...
Seatbelts
...
Other materials:
Ignition switch (models without "keyless access with push-button start
system")
WARNING
Never turn the ignition switch to
the "LOCK" position while the
vehicle is being driven or towed
because that will lock the steering
wheel, preventing steering
control. And when the engine is
turned off, it takes a much greater
effort than usual to steer.
Before leaving t ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Case and Extension Case AssemblyINSTALLATION1. Clean the mating surfaces of the transmission case, transfer case and extension case.2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the rolle ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Pump RelayREMOVAL1. Disconnect the ground cable from battery.2. Remove the glove box. Glove Box > REMOVAL">3. Remove the fuel pump relay from relay block. ...
