Subaru Crosstrek Service Manual: Removal
EXHAUST(H4DO) > Center Exhaust Pipe
REMOVAL
CAUTION:
Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
1. Turn the ignition switch to OFF.
2. Lift up the vehicle.
3. Remove the bolts, springs, and nuts securing the rear exhaust pipe to the center exhaust pipe.
4. Remove the bolt which holds center exhaust pipe to hanger bracket.
5. Remove the center exhaust pipe from the front exhaust pipe.
6. Remove the center exhaust pipe upper cover from the center exhaust pipe.
Inspection
EXHAUST(H4DO) > Center Exhaust PipeINSPECTION1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting. ...
Installation
EXHAUST(H4DO) > Center Exhaust PipeINSTALLATION1. Install the center exhaust pipe upper cover to the center exhaust pipe.Tightening torque:13 N·m (1.3 kgf-m, 9.6 ft-lb)2. Temporarily tighten ...
Other materials:
Component
WHEEL AND TIRE SYSTEM > General DescriptionCOMPONENT(1)Screw(4)TPMS & keyless entry control moduleTightening torque: N·m (kgf-m, ft-lb)(2)Transmitter (snap in type)(5)TPMS CMT1:1.4 (0.14, 1.0)(3)Valve T2:7.5 (0.76, 5.5) T3:13 (1.33, 9.6)(1)TPMS & keyless entry control module(2) ...
Dtc p2195 a/f /o2 sensor signal biased/stuck lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2195 A/F /O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...
Note
LIGHTING SYSTEM > Day Time Running Light SystemNOTEFor operation procedures of each component of the daytime running light system, refer to the respective section.• Headlight Assembly: Headlight Assembly">• Headlight bulb: Headlight Bulb">• Combination switch ( ...
