Subaru Crosstrek Service Manual: Removal
BRAKE > Brake Hose
REMOVAL
1. FRONT BRAKE HOSE
1. Disconnect the brake pipe (b) from the brake hose (a).
Preparation tool:
Flare nut wrench
2. Remove the clamp, strut mounting bolt and union bolt, and remove the front brake hose.
2. REAR BRAKE HOSE
1. Remove the brake hose bracket bolt and union bolt.
2. Disconnect the brake pipe (a).
Preparation tool:
Flare nut wrench
3. Remove the brake hose clamp (b), and remove the rear brake hose (c).
Inspection
BRAKE > Brake HoseINSPECTIONCheck the hose for crack, interference with other parts, damage, and fluid leakage on connecting sections. If any faulty is found, repair or replace the relevant part. ...
Installation
BRAKE > Brake HoseINSTALLATION1. FRONT BRAKE HOSE1. Secure the brake hose to strut mount.Tightening torque:Brake hose: 33 N·m (3.36 kgf-m, 24.3 ft-lb)2. Connect the brake hose to the front c ...
Other materials:
Installation
BRAKE > Brake PipeINSTALLATIONCAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuit ...
ECO history screen
Average fuel consumption per unit time
(bar graph)
Average fuel consumption corresponding
to the driving distance of each trip meter
(red line)
This screen displays the fuel economy
history for the vehicle using a bar graph.
The horizontal scale represents the past
time range ...
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeINSTALLATION1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.NOTE:Use a new gasket.Tightening torque:6.4 N·m (0.7 kgf-m, 4. ...
