Subaru Crosstrek Owners Manual: Rear gate - if the rear gate cannot be opened
In the event that you cannot open the rear gate by operating the rear gate opener button, you can open it from inside the cargo area.
1. Remove the access cover at the bottom-center of the rear gate trim using a flat-head screwdriver wrapped with vinyl tape or a cloth.
2. Locate the rear gate open lever behind the rear gate trim panel.
CAUTION
Never operate the rear gate open lever with fingers because doing so may cause an injury. Always use a flat-head screwdriver or a similar tool.
3. To open the rear gate, turn the lever to the right position using a flat-head screwdriver or a similar tool.
Starting engine
1. Apply the parking brake.
2. Shift the select lever into the "P"
position.
3. Depress the brake pedal.
4. Hold the access key with the buttons
facing you, and touch the push-button
ign ...
If your vehicle is involved in an accident
CAUTION
If your vehicle is involved in an
accident, be sure to inspect the
ground under the vehicle before
restarting the engine. If you find that
fuel has leaked on the ground, do
not try to re ...
Other materials:
Brake fluid level warning
This light illuminates when the brake fluid
level has dropped to near the "MIN" level
of the brake fluid reservoir with the ignition
switch in the "ON" position and with the
parking brake fully released.
If the brake system warning light should
illuminate while driving (with the parking
bra ...
Windshield wipers
Mist (for a single wipe)
Off
Intermitten
Low speed
High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the " " position.
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release the lever. ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure SensorINSPECTION1. Start and warm up the engine.2. Depress the brake pedal, and shift the select lever to “D” range.3. Shift the select lever to “P” or “N” range.4. Depress the brake pedal and hold ...
