Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: If your vehicle is involved in an accident

Subaru Crosstrek Owners Manual / In case of emergency / If your vehicle is involved in an accident

CAUTION

If your vehicle is involved in an accident, be sure to inspect the ground under the vehicle before restarting the engine. If you find that fuel has leaked on the ground, do not try to restart the engine. The fuel system has been damaged and is in need of repair. Immediately contact the nearest automotive service facility.

We recommend that you consult your SUBARU dealer.

Your vehicle has a fuel pump shut off system. To minimize the risk of fire due to fuel leakage when your vehicle is subject to impact from an accident or another factor, the system stops supplying fuel.

However, depending on the impact conditions at the time of collision, the fuel pump shut-off system may not operate.

Perform the following procedures to restart the engine after the system is activated.

Models without "keyless access with push-button start system":

1. Turn the ignition switch to the "LOCK" or "ACC" position.

2. Restart the engine.

1. Turn the ignition switch to the "LOCK" or "ACC" position.

2. Restart the engine.

1. Turn the push-button ignition switch to the "ACC" or "OFF" position.

2. Restart the engine.

Rear gate - if the rear gate cannot be opened
In the event that you cannot open the rear gate by operating the rear gate opener button, you can open it from inside the cargo area. 1. Remove the access cover at the bottom-center of the re ...

Appearance care
...

Other materials:

Dtc b2a05 left speaker/audio circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A05 LEFT SPEAKER/AUDIO CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:Speaker impedance is more than 10 k? for 100 ms. (Detached speaker connection, etc.)Trouble symptom:• ...

Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyDISASSEMBLY1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL4. Using the ST, r ...

Installation
SECURITY AND LOCKS > Steering Lock CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FOR ...

© 2016-2026 Copyright www.sucross.com