Subaru Crosstrek Service Manual: Rear differential inspection mode

Replacement

DIFFERENTIALS > Rear Differential Front Oil SealREPLACEMENT1. Shift the select lever or gear shift lever to neutral.2. Release the parking brake.3. Disconnect the ground cable from battery.4. Lift ...

Procedure

DIFFERENTIALS > Rear Differential Inspection ModePROCEDURECAUTION:Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.1. Shift the sele ...

Other materials:

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyINSPECTION1. CHECK MOTOR1. Connect the battery positive terminal to terminal No. 5 and the battery ground terminal to terminal No. 4, and check that the valve is fully opened on LH side and the valve is fully closed on RH side.C ...

Basic diagnostic procedure Procedure
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Before performing all diagnostics or cruise control diagnostics, always start the engine and make sure that the initial illumination of the ABS/VDC warning light has been ended. (If you start the diagnostics ...

System operation
Operating conditions The BSD/RCTA will operate when all of the following conditions are met. The ignition switch is in the "ON" position. The BSD/RCTA warning indicator and BSD/RCTA OFF indicator are turned off. The vehicle is driven at speeds above 6 mph (10 km/h) (except when rever ...