Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation

1. SUBARU SELECT MONITOR

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Engine Control System» and then «Enter».

5. On «Select Function» display, select «DTC».

Refer to general scan tool manufacturer’s instruction manual to access powertrain DTC (MODE $03).

List of diagnostic trouble code (dtc) List

Subaru select monitor Operation

Other materials:

Preparation tool
SPEED CONTROL SYSTEMS(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer ...

Ending screen
If "Eco Summary" is set to "On" in the "Bypass screen setting", the "Fuel consumption results screen" will be displayed before the screen turns off when the ignition switch is turned to the "LOCK"/ "OFF" position. Fuel consumption results screen The average fuel consumption for the e ...

Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Contact surface of lever and bearing• Transmission main shaft spline• Contact surface of rele ...