Subaru Crosstrek Service Manual: Procedure

CAUTION:

• Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.

• On completing the work in FWD, switch back in AWD.

1. Shift the select lever to “P” range.

2. Connect the Subaru Select Monitor to data link connector.

3. Turn the ignition switch to ON.

4. Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.

5. Select «Diagnosis» in the «Start» screen of Subaru Select Monitor.

6. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

7. On «Main Menu» display, select «Each System».

8. On «Select System» display, select «Transmission Control System».

9. On «Select Function» display, select «Work Support».

10. Select «AWD ON/OFF switching mode» in the «Work Support» screen.

11. Follow the messages displayed on the Subaru Select Monitor screen when working.

Switching completes successfully if any of the following messages is displayed.

• When switching from AWD to FWD: «Switched to FF. To return to AWD, perform basic mode again.»

• When switching from FWD to AWD: «Switched to AWD. To return to FF, perform basic mode again.»

• If communication error occurs during switching mode, start in the «AWD ON/OFF switching mode» again.

• If operation is interrupted before the successful end message is displayed, perform the «AWD ON/OFF switching mode» from the beginning until confirming the operation is successfully ended. If this mode fails to complete successfully, the cause is as follows.

• Select lever is not in “P” range.

• Engine is running.

Awd on/off switching mode

General description

Other materials:

Removal
MECHANICAL(H4DO) > Cylinder HeadREMOVAL1. CYLINDER HEAD RH1. Remove the engine from the vehicle. Engine Assembly > REMOVAL">2. Remove the intake manifold. Intake Manifold > REMOVAL">3. Remove the engine wiring harness. Engine Wiring Harness > REMOVAL">4. Remove ...

Inspection
LIGHTING SYSTEM > SRF OFF SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3OFF1 M? or moreONLess than 1 ?2. Apply battery voltage between the connector terminals to check lighting condition of illu ...

Note
GLASS/WINDOWS/MIRRORS > Power Window SystemNOTEFor operation procedures of each component of the power window system, refer to the respective sections.• Power window control switch: Power Window Control Switch">• Front door glass: Front Door Glass">• Front regu ...