WIPER AND WASHER SYSTEMS > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |

—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
DST-i | Used together with Subaru Select Monitor 4. |
Component
Rear washerInstallation
DRIVE SHAFT SYSTEM > Front AxleINSTALLATION1. Install the front drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the hub spline, and pull it into the specified position.(2) Tighten the ax ...
Inspection
BRAKE > Front Disc RotorINSPECTION1. DISC ROTOR RUNOUT CHECK1. Check the hub unit COMPL - front axle for free play and runout before the inspection of disc rotor runout limit. Front Hub Unit Bearing > INSPECTION">2. Tighten the wheel nuts to secure disc rotor.3. Set a dial gauge 10 mm ...
Rear gate - if the rear gate cannot be opened
If the rear gate of your Subaru Ascent cannot be opened using the standard external
button, it is possible to unlock it manually from inside the cargo area as an emergency
measure.
1. Carefully remove the access panel located at the lower center of the rear
gate trim. Use a flat-head scre ...