Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Preparation tool

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General Description

PREPARATION TOOL

1. SPECIAL TOOL

ILLUSTRATION

TOOL NUMBER

DESCRIPTION

REMARKS

SUBARU SELECT MONITOR 4

Used for setting of each function and troubleshooting for electrical system.

NOTE:

For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.

2. GENERAL TOOL

TOOL NAME

REMARKS

Circuit tester

Used for measuring resistance, voltage and current.

DST-i

Used together with Subaru Select Monitor 4.

Caution
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipmen ...

Inspection
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTIONCheck the battery. Battery > INSPECTION"> ...

Other materials:

Dtc p0016 crankshaft position - camshaft position correlation bank 1 sensor a
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0016 CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION BANK 1 SENSOR ADTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improp ...

Removal
LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector and remove the switch assembly - door. ...

Dtc u0416 invalid data received from vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEReceived error data from VDC CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROC ...

© 2016-2025 Copyright www.sucross.com