Subaru Crosstrek Service Manual: Installation

CAUTION:

• Do not reuse the bolt and nut.

Always replace with the specified new bolts and nuts.

• When installing the cover - satellite safing, push the cover securely until it contacts the floor panel.

• If the cover - satellite safing is too loose at its mounting portion to remove easily, replace with a new cover - satellite safing.

• After installing the cover - satellite safing, make sure that the sensor harness does not get caught.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• The satellite safing sensor connector is damaged.

• The cover - satellite safing is damaged.

• Side airbag or curtain airbag has been activated.

2. Install the remaining parts in the reverse order of removal.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Satellite safing sensor

Removal

Other materials:

Installation
BRAKE > Rear Brake PadINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly and support - rear disc brake.1. Before installation, check the brake pad. Rear Brake Pad > INSPECTION">2. Apply a thin coat of grease to the pad clip.Preparation i ...

Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid ValveINSPECTION1. PURGE CONTROL SOLENOID VALVE1. Check that the purge control solenoid valve has no deformation, cracks or other damages.2. Measure the resistance between the purge control solenoid valve terminals.Ter ...

Dtc b2350 rear radar communication error between master and slave
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2350 REAR RADAR COMMUNICATION ERROR BETWEEN MASTER AND SLAVEDTC DETECTING CONDITION:• Defective harness for CAN communication between radar sensor LH and radar sensor RH ...