Subaru Crosstrek Owners Manual: Outside mirrors
Convex mirror (passenger side)
WARNING
Objects look smaller in a convex mirror and farther away than when viewed in a flat mirror. Do not use the convex mirror to judge the distance of vehicles behind you when changing lanes. Use the inside mirror (or glance backwards) to determine the actual size and distance of objects that you view in convex mirror.
Remote control mirror switch
Select side to adjust
Direction control
The remote control mirrors operate only when the ignition switch is in the "ON" or "ACC" position.
1. Turn the control switch to the side that you want to adjust. "L" is for the left mirror, "R" is for the right mirror.
2. Move the control switch in the direction you want to move the mirror.
3. Return the control switch to the neutral position to prevent unintentional operation.
The mirrors can also be adjusted manually.
Inside mirror
The inside mirror has a day and night
position. Pull the tab at the bottom of the
mirror toward you for the night position.
Push it away for the day position. The
night position reduces glar ...
Defogger and deicer
Rear window defogger
Outside mirror defogger (if equipped)
Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear
window defogger. Some models are also
equipped with ...
Other materials:
Dtc c1732 lateral g sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1732 LATERAL G SENSORDTC detecting condition:Defective lateral G sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.ST ...
Dtc p0103 mass or volume air flow sensor "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0103 MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving performanc ...
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnINSTALLATIONCAUTION:If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode.– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H ...
