Subaru Crosstrek Service Manual: Operation
ENTERTAINMENT > Telematics System
OPERATION
1. REGISTRATION (COMM CHECK)
CAUTION:
Because it will go back to Factory mode when the signal is weak, that you do not press the i button more than 2 seconds during a communication check. If it had returned to Factory mode, carrying out the CommCheck again. Each mode state can be confirmed in the “Subscription Status” in the current data display of SSM.
1. Replace the data communication module with a new part.
2. Check the LED of overhead console or stereo camera cover assembly illuminates in green.
3. Press and hold the i-button for 2 seconds or more.
NOTE:
When the subscription is completed, the telematics system will automatically activate.
Note
ENTERTAINMENT > Telematics SystemNOTEFor procedure of each component in the telematics system, refer to the respective section.• Data communication module: Data Communication Module"> ...
Check list for interview Check
ENTERTAINMENT > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.1. MODEL WITH 6.2 INCH DI ...
Other materials:
Ventilator control
Center and side ventilators
Center ventilators
Open
Close
Side ventilators
Open
Close
To adjust the flow direction, move the tab.
To open or close the ventilator, turn the
thumb-wheel up or down. ...
Engine overheating
WARNING
Never remove the radiator cap of your Subaru Ascent until the engine has been
completely switched off and allowed to cool down fully. When the engine is hot,
the cooling system remains under high pressure.
Opening the cap prematurely may cause a sudden release of pressurized, boiling ...
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" 2-30.
2. Sit in the driver's seat and shut all
doors and the rear gate.
3. Turn the ignition switch to the "ON"
position.
...
