Subaru Crosstrek Owners Manual: Maintenance tools
Your vehicle is equipped with the following maintenance tools.
- Jack
- Jack handle
- Screwdriver
- Towing hook (eye bolt)
- Wheel nut wrench
Temporary spare tire
WARNING
Never tow a trailer when the
temporary spare tire is used.
The temporary spare tire is not
designed to sustain the towing
load. Use of the temporary spare
tire when towing can ...
Tool locations
Jack handle
Tool bucket
Spare tire
Wheel nut wrench
Screwdriver
Jack
Towing hook (eye bolt)
A jack handle is stored under the floor of
the cargo area. A jack and a towin ...
Other materials:
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the clips, and remove the under cover assembly - passenger.3. Remove the blower - motor.(1) Disconnect the connector.(2) Remove the screws and detach the blower - m ...
Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...
Dtc c2513 torque sensor much tolerance
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2513 TORQUE SENSOR MUCH TOLERANCENOTE:Refer to “DTC C2511 TORQUE SENSOR MAIN” for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC ...
