Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > List of Cancel Code
LIST
Code | Item | Contents of diagnosis |
B2320 | Rear RADAR Low Voltage (less than 9V) | Temporarily stops because the voltage supplied to radar drops below 9 V. Returns to normal when the voltage becomes normal. |
B2321 | Rear RADAR High Voltage (more than 16V) | Temporarily stops because the voltage supplied to radar rises to or above 16 V. Returns to normal when the voltage becomes normal. |
B2328 | Rear RADAR internal failure (RADAR misalignment) | Deviation of the radar axis prevents normal detection. Returns to normal when the radar axis becomes normal. When B2328 is frequently detected, perform “Diagnostic Procedure with Cancel Code”. Diagnostic Procedure with Cancel Code > DTC B2328 REAR RADAR INTERNAL FAILURE (RADAR MISALIGNMENT)"> |
B2340 | RADAR ASSY B&S out of operation temperature range | Temporarily stops because the temperature is outside the operative range (−40°C (−40°F) — 85°C (185°F)). Returns to normal when the ambient temperature falls within the operative range. |
B2341 | Rear RADAR degradation of detecting performance | Temporarily stops because some obstacles blocked radar waves of the back and side radar. Returns to normal when the transmission and reception of radar signals becomes normal. |
Inspection mode Operation
List of diagnostic trouble code (dtc) ListInstallation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSTALLATION1. Install the fuel sub level sensor to the fuel tank.(1) Make sure the sealing portion is free from fuel or foreign matter before installation.(2) Align the cutout (B) as shown in the figure, and install the fuel sub level se ...
Inspection
COMMUNICATION SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and check visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection conditionsSpecificationCircuit1 — 2Always1 M? or more1 — 2Apply ...
Dtc p0017 crankshaft position - camshaft position correlation bank 1 sensor b
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0017 CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION BANK 1 SENSOR BDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improp ...