Subaru Crosstrek Service Manual: Keyless access system check Operation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Keyless Access System Check
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Keyless Access with Push Button Start» and then select «Enter».
5. On «Select Function» display, select «Work Support».
6. On «Work Support» display, select «Keyless access system check».
7. Select a transmitter to be checked.
Data | Customize setting | Remarks | |
Keyless access system check | Driver side external transmitter - internal tuner | When the setting content on the left is selected, the access key is neared to the selected transmitter (access antenna) and collation matches, the buzzer will sound. | |
Passenger side external transmitter - internal tuner | |||
Fr internal transmitter - internal tuner | |||
Rr internal transmitter - internal tuner | |||
R gate internal transmitter - internal tuner | |||
R gate external transmitter - internal tuner | |||
Immobilizer amplifier transmission | |||
Collation result history Clear | Operate | ||
— | |||
NOTE:
For detailed operation procedures, refer to “Application help”.
General diagnostic table Inspection
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTION1. IMMOBILIZER SYSTEMSymptomsNoteEngine does not start Diagnostics with Phenomenon > INSPECTION&quo ...
List of diagnostic trouble code (dtc) List
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LIST(1) Keyless access systemDTCItemContent of diagnosisNoteU0073CONTROL MODULE COMMUNICATION BUS O ...
Other materials:
Electrical specification
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Models without EyeSightNOTE:• Terminal numbers in VDCCM&H/U connector (on the control module side) are shown in the figure.• When the connector is removed from the VDCCM&H/U ...
Installation
LUBRICATION(H4DO) > Oil Level SwitchINSTALLATION1. Install the oil level switch and the clip (A) to the oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the engine mounting LH onto the en ...
Dtc u0073 control module communication bus off
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&q ...
