Subaru Crosstrek Service Manual: Installation

CAUTION:

Do not reuse the bolt and nut.

Always replace with the specified new bolts and nuts.

1. Before installation, inspect the following items and replace any faulty part with a new part.

• The side airbag sensor, sensor bracket, or connector are damaged.

• Side airbag module has been activated.

• Curtain airbag module has been activated.

Tightening torque:

Side airbag sensor: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

2. Install each part in the reverse order of removal.

NOTE:

Assemble the trim panel - center pillar LWR to the trim panel - center pillar UPR securely.

Tightening torque:

Front seat belt: General Description > COMPONENT">

Side airbag sensor

Removal

Other materials:

Note
LIGHTING SYSTEM > Interior Light SystemNOTEFor operation procedures of each component of the interior light system, refer to the respective section.• Spot map light: Spot Map Light">• Room light: Room Light">• Luggage room light: Luggage Room Light">&b ...

Installation
SECURITY AND LOCKS > Security Control ModuleINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MAN ...

Installation
SECURITY AND LOCKS > Front Hood Lock AssemblyINSTALLATION1. Before installation, check the following items.• Is the cable deformed?• Grease is applied sufficiently to cable joints.If grease is insufficient, add it as necessary before assembling the cable.2. Install each part in the re ...