Subaru Crosstrek Service Manual: Installation

1. Install in the reverse order of removal.

2. Operate the rear wiper once.

3. Align the blade assembly - rear wiper with the marking on the glass, and then tighten the nut to the specified torque.

Tightening torque:

8 N·m (0.82 kgf-m, 5.9 ft-lb)

4. Operate the wiper to check whether the wiper blade aligns with the point mark. If not, perform installation over again.

Removal

Rear wiper motor

Other materials:

Sun visor extension plate (models with the EyeSight system)
With the sun visor positioned over the side window, you can use the sun visor extension plate to prevent glare through the gap between the sun visor and center pillar. To use the extension plate, pull it toward the rear of the vehicle. When you have finished using it, stow it by pushing it ...

Stowage of the cargo area cover
The cargo area cover can be stowed in under the cargo floor. 1. Raise and fold the rear end of the cargo floor board. 2. Stow the cover housing in the cargo area end. 3. Put the cargo floor board back while hanging two retaining straps on the hooks that are located on the rear wa ...

Installation
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseINSTALLATIONCAUTION:Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.1. Install the nozzle - windshield washer.(1) Install the nozzle - windshield washer.(2) Install the hose - windsh ...