The cargo area cover can be stowed in under the cargo floor.

1. Raise and fold the rear end of the cargo floor board.

2. Stow the cover housing in the cargo area end.

3. Put the cargo floor board back while hanging two retaining straps on the hooks that are located on the rear wall of cargo area.
To install the cover housing
1. Shorten the cover housing

2. Insert both ends of the cover housing into the recesses of the retainers.
To remove the cover housing
Cargo tie-down hooks (if equipped)Removal
LIGHTING SYSTEM > Luggage Room LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - luggage room.CAUTION:When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage.(1) Release the claws and remove the main ...
Inspection
LAN SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTION1. INSPECTION WITHOUT USING CAN DIAGNOSTICBefore performing diagnosis, check the following items that might affect troubles of each module.1. Check the battery. Battery > INSPECTION">2. Check the fuse condition.Make sure that amp ...
Removal
MECHANICAL(H4DO) > Crank PulleyREMOVALNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remove the radiator main fan & fan motor assembly and radia ...