SEATS > Rear Seat
INSTALLATION
Install each part in the reverse order of removal.
NOTE:
• After installing the backrest assembly, make sure that each seat belt operates normally.
• Make sure that they are properly secured on each hook on the vehicle side.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
InspectionRemoval
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...
General diagnostic table Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONSymptomsFaulty partsTire pressure warning light illuminates.Tire pressure is reduced.• Improper tire pressure adjustment• Punctured tireTire pressure warning light blinks 25 times and then illuminates.Ti ...
Component
MECHANICAL(H4DO) > General DescriptionCOMPONENT1. TIMING CHAIN(1)Intake camshaft RH(8)Chain tensioner RH(15)Exhaust camshaft LH(2)Exhaust camshaft RH(9)Crank sprocket (3)Intake cam sprocket RH(10)O-ringTightening torque: N·m (kgf-m, ft-lb)(4)Exhaust cam sprocket RH(11)Chain tensioner LHT1 ...