Subaru Crosstrek Service Manual: Installation
PARKING BRAKE > Parking Brake Cable
INSTALLATION
1. Install each part in the reverse order of removal.
Tightening torque:
Cable clamp: 18 N·m (1.84 kgf-m, 13.3 ft-lb)
Rear wheel: Except for C4 model
120 N·m (12.24 kgf-m, 88.5 ft-lb)
Rear wheel: C4 model
100 N·m (10.20 kgf-m, 73.8 ft-lb)
NOTE:
• Apply grease to the cable guide inside the tunnel, and pass the cable through.
• After installing the backrest assembly, make sure that each seat belt operates normally.
• Make sure that they are properly secured on each hook on the vehicle side.
2. Be sure to adjust the lever stroke. Parking Brake Lever > ADJUSTMENT">
Other materials:
Accessory power outlets
Power outlet below the climate control dials
Power outlet in the center console
Accessory power outlets are provided
below the climate control dials and in the
center console. Electrical power (12V DC)
from the battery is available at any of the
outlets when the ignition switch is in e ...
Removal
LIGHTING SYSTEM > SRF OFF SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - instrument panel LWR driver OUT. Instrument Panel Lower Cover > REMOVAL">3. Release the claws, and then remove the cover.4. Release the claws and remove th ...
Installation
FRONT SUSPENSION > Front StabilizerINSTALLATION1. Before installation, inspect the following items and replace any faulty part with a new one.• Check the bushing - stabilizer for abnormal cracks, fatigue or damage.• Check the stabilizer link for damage.2. Install each part in the reve ...
