Subaru Crosstrek Service Manual: Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater and Cooling Unit
INSTALLATION
CAUTION:
• Replace O-rings with new parts and install securely.
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Install each part in the reverse order of removal.
Tightening torque:
Heater and cooling unit: General Description > COMPONENT">
Air conditioning unit: General Description > COMPONENT">
2. Fill engine coolant. Engine Coolant > REPLACEMENT">
3. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater and Cooling UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in ...
Other materials:
Bulb chart
NOTE
Lights A and B are the LED (Light Emitting Diode) type. Consult your
SUBARU dealer for replacement.
Wattage
Bulb No.
1) High beam headlight
12V-60W
HB3
2) Low beam headlight
Models with HID light
Models with halogen light
...
Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0717 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock ...
Installation
ENTERTAINMENT > AntennaINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer to “CAUTION” of ...
