Subaru Crosstrek Service Manual: Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion Valve
INSTALLATION
CAUTION:
Replace the O-rings with new parts, and then apply compressor oil.
1. Install each part in the reverse order of removal.
Tightening torque:
Heater and cooling unit: General Description > COMPONENT">
Air conditioning unit: General Description > COMPONENT">
2. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">
Expansion valve
...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion ValveREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Using the refrigerant recovery system, discharge refrigerant. Refrig ...
Other materials:
61
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code61Malfunction in the stop light & brake switch is detected.TROUBLE SYMPTOM:• Cruise control cannot be set.• Cruise control cannot be released.Refer to DTC 12 for diagnostic procedure. Diagnostic Procedure w ...
Procedure
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Preparation for OverhaulPROCEDURE1. Clean the transmission exterior.2. Remove the torque converter assembly. Torque Converter Assembly">3. Attach the ST on the transmission.ST 18632AA000STAND ASSY4. Remove the transmission case cover on the ...
Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. Install the inner race to the shaft.(1) Install the boot (BJ) or boot (EBJ) in the specified position, ...
