EXTERIOR BODY PANELS > Rear Sealing Cover
INSTALLATION
CAUTION:
• If the sealing cover - rear door gets broken, replace it with a new part.
• Apply a butyl tape evenly.
• Attach the sealing cover - rear door, keeping it from becoming wrinkled.
• If the butyl tape is applied unevenly, it will cause water leakage and soiling.
1. Install the sealing cover.
(1) Forcefully push the butyl tape portion to prevent any floating on surface.
(2) When replacing the sealing cover, use the butyl tape.
Preparation items:
Butyl tape: 3M Butyl Rubber 8626 or equivalent
2. Install each part in the reverse order of removal.
NOTE:
Before installation, check the following items.
• Is the lever of the frame assembly - rear door outer is free from deformation?
• Is grease applied sufficiently to the lever joints of the latch and actuator assembly - rear?
• Is the cable of the latch and actuator assembly - rear free from deformation such as fray?
• Is grease applied sufficiently to the cable joints of the latch and actuator assembly - rear?
Removal
Protector tape InstallationTo increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Press the "RES/SET" switch to the
"SET" side once. Now the desired speed
is set and the vehicle will keep running at
that speed without depressing the accelerator
pedal.
NOTE
U.S.-spec. models
If t ...
Removal
SECURITY AND LOCKS > Accessory Relay (Push Button Start)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from b ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Manual Transmission AssemblyINSTALLATION1. Replace the differential side retainer oil seal. Differential Side Retainer Oil Seal > REPLACEMENT">NOTE:• Be sure to replace the oil seal after removing the front drive shaft.• When a n ...