Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid Valve
INSTALLATION
Install in the reverse order of removal.
NOTE:
• Hold the purge control solenoid valve unit by hand to prevent it from rotating together.
• Connect the vacuum hose as shown in the figure.
(a) | To intake manifold | (b) | To fuel pipe |
• Check that the vacuum hose is securely held to the intake manifold and intake manifold clip (A).
Tightening torque:
3.4 N·m (0.3 kgf-m, 2.5 ft-lb)
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the bolt which holds the purge control solenoid val ...
Other materials:
Check list for interview Check
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Check List for InterviewCHECKCheck the following items regarding condition of the vehicle.1. TROUBLE STATUSPhenomenon of the vehicle Steering is heavy Steering is not smooth Steering is unstable (wondering) Steering does not return to center ...
On-road and off-road driving
WARNING
Always adapt your driving speed in the Subaru Ascent to match current
road, traffic, and weather conditions. Excessive speed during cornering, braking,
or sudden maneuvers can significantly increase the risk of accidents.
Even though the Subaru Ascent is equipped with an advanced ...
Inspection
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable is faulty, replace the latch & actuator assembly - rear.2. ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied ...
