Subaru Crosstrek Service Manual: Installation

Subaru Crosstrek Service Manual / Continuously variable transmission(tr580) / Turbine speed sensor / Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed Sensor

INSTALLATION

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.

Install in the reverse order of removal.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-ring.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, re ...

Variator chain

...

Other materials:

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Case and Extension Case AssemblyREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness &g ...

Procedure
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Preparation for OverhaulPROCEDURE1. Clean the transmission exterior.2. Remove the torque converter assembly. Torque Converter Assembly">3. Attach the ST on the transmission.ST 18632AA000STAND ASSY4. Remove the transmission case cover on the ...

Tachometer
The tachometer shows the engine speed in thousands of revolutions per minute. CAUTION Do not operate the engine with the pointer of the tachometer in the red zone. In this range, fuel injection will be cut by the engine control module to protect the engine from overrevving. The engine will ...