Subaru Crosstrek Service Manual: Installation

1. Install the O-ring to the input shaft.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-ring.

2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.

NOTE:

• Apply CVTF to the oil seal lip.

• Do not damage the oil seal and O-ring.

3. Engage the splines while gently rotating the torque converter assembly by hand, and securely insert the assembly.

4. Measure depth “A”, from converter case end surface to drive plate contacting surface.

Standard (reference):

6.8 mm (0.268 in) or less

5. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Removal

Transfer clutch

Other materials:

Starting engine
WARNING There are some general precautions when starting the engine. Carefully read the precautions described in "General precautions when starting/stopping engine" F7-9. If the indicator on the pushbutton ignition switch flashes in green after the engine has started, never dri ...

Installation
LIGHTING SYSTEM > Front Fog Light AssemblyINSTALLATIONCAUTION:Install the mud guard - front so that the front end of the mud guard (b) comes outside the bumper face - front (a).1. Install each part in the reverse order of removal.Tightening torque:Fog light assembly - front: 7.5 N·m (0.76 ...

Installation
PARKING BRAKE > Parking Brake CableINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Cable clamp: 18 N·m (1.84 kgf-m, 13.3 ft-lb)Rear wheel: Except for C4 model120 N·m (12.24 kgf-m, 88.5 ft-lb)Rear wheel: C4 model100 N·m (10.20 kgf-m, 73.8 ft- ...