Subaru Crosstrek Service Manual: Installation

1. Clean the mating surface of oil pan and transmission case.

2. Install the O-ring to the oil strainer.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

3. Install the oil strainer.

Tightening torque:

9 N·m (0.9 kgf-m, 6.6 ft-lb)

4. Clean the magnet.

5. Attach the magnet at the specified position of the oil pan.

6. Apply liquid gasket all around the oil pan mating surface seamlessly.

Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

7. Install the oil pan by equally tightening the bolts.

Tightening torque:

5 N·m (0.5 kgf-m, 3.7 ft-lb)

8. Refill CVTF and adjust the level. CVTF > REPLACEMENT">

Removal

Oil pump

Other materials:

Caution
EyeSight (DIAGNOSTICS) > General DescriptionCAUTION1. AIRBAG SYSTEMAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage t ...

How to use keyless access functions
Keyless access function tips Turn off the push-button ignition switch before locking the doors (including rear gate) using the keyless access function. It is not possible to lock the doors (including the rear gate) using the keyless access function when the push-button ignition switc ...

Removal
EXTERIOR/INTERIOR TRIM > Roof MoldingREMOVALCAUTION:Be careful not to damage the body.1. Remove the roof rail assembly. (model with roof rail) Roof Rail > REMOVAL">2. Turn over the front end of the molding - roof.3. Slide the inner fastener in the direction of the arrow using a flat t ...