CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Air Breather Hose
INSTALLATION
1. FRONT DIFFERENTIAL SIDE
Install in the reverse order of removal.
NOTE:
Securely insert the air breather hose until the hose end contacts the catch of the pitching stopper bracket.
2. TRANSMISSION CASE SIDE
Install in the reverse order of removal.
Tightening torque:
Transmission case cover:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
Air breather hose:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
NOTE:
After the transmission case cover (large) is installed, insert the transmission case cover (small) between the transmission case cover (large) and the transmission to install.
Fuel filler lid and cap
Locations of the fuel filler lid and
the lid release lever
Fuel filler lid
Fuel filler lid release lever
Refueling
Only one person should be involved in
refueling. Do not allow others to approach
the area of the vehicle near the fuel filler
pipe while refueling is in progress.
Be ...
Installation
MECHANICAL(H4DO) > Cylinder BlockINSTALLATION1. Apply engine oil to the crankshaft bearing, and install the crankshaft bearing to the cylinder block.CAUTION:• Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.• ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSTALLATIONCAUTION:• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil ...