Subaru Crosstrek Service Manual: Installation
BRAKE > Brake Pipe
INSTALLATION
CAUTION:
• Be careful of the following items. Failure to do so may cause the airbag system malfunction.
– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION">
– Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
• Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
• When removing the brake pipe, do not bend.
• After installing the brake pipe and hose, perform air bleed.
• After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
NOTE:
The airbag system wiring harness is routed near the center brake pipe.
Tightening torque:
Front brake pipes & hoses: General Description > COMPONENT">
Center & rear brake pipes and hoses: General Description > COMPONENT">
Removal
BRAKE > Brake PipeREMOVALCAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes around th ...
Front brake pad
...
Other materials:
Dtc b1816 open in passenger s airbag dual stage - 2nd step
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1816 OPEN IN PASSENGER’S AIRBAG DUAL STAGE - 2ND STEPDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is open.• Airbag module harness (passenger&r ...
Removal
BRAKE > Brake PipeREMOVALCAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, fo ...
Pressure switch (triple pressure switch) Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Pressure Switch (Triple Pressure Switch)INSPECTION1. Connect the manifold gauge to the service valve on the high-pressure side.2. Disconnect the connector.3. Start the air conditioner, and check the operating pressure of switch by turning the compressor ...
