Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection mode Procedure

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Inspection Mode

PROCEDURE

Road Test">

Electrical component location Location
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Electrical Component LocationLOCATION1. CONTROL MODULE(1)Transmission control module (TCM)(3)AWD light(5)Body integrated unit(2)AT OIL TEMP light( ...

List of diagnostic trouble code (dtc) List
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContent of diagnosisReferenceP0500VEHICLE SPEED SENSOR "A" CIRCUITWheel speed data from ...

Other materials:

Drive cycle Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Drive CyclePROCEDUREIt is necessary to perform the drive cycle listed below if DTC is not found in the Inspection Mode. It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cyc ...

Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyINSTALLATION1. Install the leak check valve assembly to the vehicle with the bolt and clip (A).Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Connect the connector to the leak check valve assembly.3. Conn ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)REMOVAL1. Disconnect the ground cable from battery.2. Remove the glove box. Glove Box > REMOVAL">3. Disconnect the connector from ECM.4. Remove the bolts and nuts, and remove the ECM. ...

© 2016-2025 Copyright www.sucross.com