Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door Actuator
INSPECTION
1. CHECK LINK
1. Visually check the operation range of the link, and remove the foreign material if any.
2. Operate the temperature control dial to check that the link operates normally.
3. If it does not operate normally as the result of inspection, check the motor - actuator mix.
2. CHECK ACTUATOR
1. Check the resistance between actuator terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connector Sketch |
3 — 1 | Always | 80 — 100 ? |
3 — 2
3 — 5
3 — 6
2. Replace the motor - actuator mix if it is found defective as a result of inspection.
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door ActuatorREMOVAL1. LHCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” ...
Other materials:
Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Read Current DataOPERATIONCheck the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt buckle switch has been replaced.1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, ...
Dtc c1531 bls off stuck
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1531 BLS OFF STUCKDTC detecting condition:Defective stop light switchTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.WIRI ...
Caution
EyeSight (DIAGNOSTICS) > General DescriptionCAUTION1. AIRBAG SYSTEMAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage t ...
