Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostics with Phenomenon
INSPECTION
(1) Perform the diagnosis according to the diagnostic procedure of the corresponding symptom that is shown in the symptom list.
(2) If there are multiple symptoms, perform the diagnosis in the symptom sequence (1 > 2 > ... > 13).
1. SYMPTOM LIST
Symptoms | Diagnostic procedure | |
1 | Nothing is displayed on the screen. No illumination appears on the indicator. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
2 | Air conditioner does not stop when pressing the OFF switch. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
3 | Windshield grass does not clear when pressing the DEF switch. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
4 | Cold air not emitted. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
5 | Warm air not emitted. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
6 | Compartment temperature is lower than setting temperature. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
7 | Compartment temperature is higher than setting temperature. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
8 | Air does not come out. Airflow is low. (Blower motor does not rotate.) | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
9 | Airflow cannot be adjusted. (Blower motor turns at a high speed.) | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
10 | Cool air does not come out when pressing the A/C switch. Fog cannot be cleared. (Compressor does not operate.) | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
11 | Unable to switch suction vents. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
12 | Unable to switch blow vents. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
13 | Illumination does not illuminate or cannot be dimmed. | Diagnostics with Phenomenon > DIAGNOSTIC PROCEDURE WITH PHENOMENON"> |
Diagnostic procedure with phenomenon
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENON1. NOTHING IS DISPLAYED ON THE SCREEN. NO ILLUMINATION APPEARS ON THE INDICATORTrouble symptom: ...
Other materials:
Adjustment
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)ADJUSTMENT1. VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight)After installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle se ...
Dtc p0113 intake air temperature sensor 1 circuit high bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0113 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH BANK 1DTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing o ...
System maintenance
NOTE
For models without "keyless access
with push-button start system":
In the event that the vehicle's battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle
a minimum of one time using the key
prior to activating the remote engine
start system. This is r ...
