Subaru Crosstrek Service Manual: Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor
INSPECTION
1. CRANKSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)
1. Prepare an oscilloscope.
2. Remove the glove box. Glove Box > REMOVAL">
3. Connect the probe to ECM connector.
Terminal No. | Probe |
16 | + |
1 | − |
4. Start the engine and let it idle.
5. Check the waveforms and voltage.
NOTE:
For waveform and voltage, refer to “Engine Control Module (ECM) I/O Signal”. Engine Control Module (ECM) I/O Signal > ELECTRICAL SPECIFICATION">
6. After inspection, install the related parts in the reverse order of removal.
2. OTHER INSPECTIONS
Check that the crankshaft position sensor has no deformation, cracks or other damages.
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake ...
Other materials:
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor OilPROCEDURENOTE:Before making repairs, perform the oil return operation to return the compressor oil in circulation with the refrigerant to the compressor assembly.1. Increase the engine speed to 1,500 r/min.2. Turn the A/C switch to ON.3. Tu ...
Dtc u0424 invalid data received from hvac control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0424 INVALID DATA RECEIVED FROM HVAC CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">1. OUTLINE OF DIAGN ...
