Subaru Crosstrek Service Manual: Inspection
WIPER AND WASHER SYSTEMS > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
2. CHECK RELAY
1. Check the resistance between relay terminals.
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 2
Apply battery voltage between terminals 4 and 3.
Less than 1 ?
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 4
Always
Less than 1 ?
1 — 2
Apply battery voltage between terminals 3 and 5.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard.
Relay and fuse
...
Location
WIPER AND WASHER SYSTEMS > Relay and FuseLOCATIONMain fuse boxFuse 30 A (wiper)(A)Relay & fuse boxFuse 7.5 A (wiper)(B)Relay holderWiper relay(C)NOTE:For other related fuses, refer to the wirin ...
Other materials:
Dtc u0073 control module communication bus off
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the radiator sub fan and fan motor assembly. Radiator Sub Fan and Fan Motor > REMOVAL">3. Lift up the vehicle.4. Remove the under cover. Front Under Cover > ...
Tire rotation
Vehicles equipped with 4 non-unidirectional tires
Front
Vehicles equipped with unidirectional tires
Front
Tire wear varies from wheel to wheel.
Move the tires to the positions shown in
the illustration each time they are rotated.
For the tire rotation schedule, refer to ...
