Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake Assembly
INSPECTION
• Inspect the drive plate facing for wear and damage.
• Check the driven plate for discoloration (burnt color).
• Check for worn snap ring, fatigue or damaged return spring or deformed spring retainer.
• Make sure the clearance between retaining plate and snap ring of reverse brake is within the limit. If it exceeds the limit, replace with a new drive plate and select and adjust the retaining plate within the initial standard value. Reverse Brake Assembly > ASSEMBLY">
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyDISASSEMBLY1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Compress the return s ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyINSTALLATION1. Select a washer. Forward Clutch Assembly > ADJUSTMENT">2. Install the selected washer to the reverse bra ...
Other materials:
Dtc p0354 ignition coil "d" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0354 IGNITION COIL "D" PRIMARY CONTROL CIRCUIT/OPENNOTE:For the diagnostic procedure, refer to DTC P0351. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0351 IGNITION COIL " ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...
SRS airbag system monitors
SRS airbag system warning light (type B)
A diagnostic system continually monitors
the readiness of the SRS airbag system
(including front seatbelt pretensioners)
while the vehicle is being driven. The
SRS airbag system warning light will show
normal system operation by illuminating
for ap ...
