Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential Assembly

INSPECTION

Check each component for scratches, damage or other faults.

Using the ST, check the backlash of pinion gear.

ST1 498247001MAGNET BASE
ST2 498247100DIAL GAUGE

Specification:

0.13 — 0.18 mm (0.0051 — 0.0071 in)

Measure the hypoid gear backlash, and then adjust it to be within specification. Front Differential Assembly > ADJUSTMENT">

Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyDISASSEMBLY1. DIFFERENTIAL CASE ASSEMBLY1. Remove the taper roller bearing using the ST.ST1 498077000REMOVERST2 89986410 ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyINSTALLATION1. Install the front differential assembly to the converter case.NOTE:Be careful not to damage the inside of the c ...

Other materials:

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Torque Converter AssemblyINSTALLATION1. Install the O-ring to the input shaft.NOTE:• Use new O-rings.• Apply CVTF to the O-ring.2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.NOTE: ...

Dtc p013a o2 sensor slow response - rich to lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013A O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clea ...

Fuel filler lid and cap
Locations of the fuel filler lid and the lid release lever Fuel filler lid Fuel filler lid release lever Refueling Only one person should be involved in refueling. Do not allow others to approach the area of the vehicle near the fuel filler pipe while refueling is in progress. Be ...

© 2016-2023 Copyright www.sucross.com