COMMUNICATION SYSTEM > Horn
INSPECTION
1. CHECK HORN ASSEMBLY
1. Remove the horn assembly (Hi & Lo). Horn > REMOVAL">
2. Check the horn sounds when applying the battery voltage to the horn assembly.

Terminal No. | Inspection conditions | Specification |
Horn terminal (+) — Horn case (−) | Connect battery to the terminals | Sounds |
3. If it does not operate normally, replace the horn assembly.
Horn
RemovalAUX
WARNING
Do not operate the player's controls
or connect the portable audio device
while driving. Doing so may result in
loss of control of your vehicle and
cause an accident or serious injury.
CAUTION
Do not leave portable audio device
in the vehicle. The temperature
inside the vehicle ...
Installation
GLASS/WINDOWS/MIRRORS > Rear Gate GlassINSTALLATIONNOTE:Use the markings on the glass to apply adhesive and primer, and to install the dam rubber - rear gate and the spacer - rear gate.(a)Marking for dam rubber - rear gate application (Ag print)(c)Marking for spacer - rear gate application (Ag pr ...
Dtc p0354 ignition coil "d" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0354 IGNITION COIL "D" PRIMARY CONTROL CIRCUIT/OPENNOTE:For the diagnostic procedure, refer to DTC P0351. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0351 IGNITION COIL " ...