Subaru Crosstrek Owners Manual: If not towing a trailer
- Remove the ball mount from the hitch receiver tube and insert the receiver cover onto the hitch receiver tube.
- Place the dust cap over the four-pin connector of the hitch wire harness to protect against possible damage.
- Occasionally lubricate terminals of the four-pin connector using terminal grease.
Connecting a trailer
Ball mount
Hitch pin
Safety pin
Hitch receiver tube
1. Insert the ball mount into the hitch
receiver tube.
2. Insert the hitch pin into the hole
located on the hitch receiver tube ...
Trailer towing
Your vehicle is designed and intended to
be used primarily as a passenger-carrying
vehicle. Towing a trailer puts additional
loads on your vehicle's engine, drivetrain,
brakes, tires and suspensio ...
Other materials:
Dtc b2300 rear radar circuit low
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2300 REAR RADAR CIRCUIT LOWDTC detecting condition:• Short circuit to ground in the harness between radar sensor and outer mirror assembly• Ground short circuit of ...
Installation
REAR SUSPENSION > Rear Sub FrameINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.• Install so that the front end of the under cover (b) com ...
Stowage of the cargo area cover
The cargo area cover can be stowed in
under the cargo floor.
1. Raise and fold the rear end of the
cargo floor board.
2. Stow the cover housing in the cargo
area end.
3. Put the cargo floor board back while
hanging two retaining straps on the hooks
that are located on the rear wa ...
